peugeot 3008 key fob not working 208 Key Replacement
Peugeot 208 key replacement should be left to professional auto locksmiths with the right equipment and technical know-how. They can create and program keys faster and less expensive than a dealership.
If your key fob has stopped locking or unlocking your doors, it could be due to a dead battery in the coin. But, there are other reasons the key could be malfunctioning.
Dead Coin Battery
A dead coin battery will stop your peugeot 207 key fob programming 208 from locking and unlocking, as well as making it impossible to start the engine. If this is the scenario, you'll need make use of the backup starting procedure that is described in the owner's manual to your vehicle.
Another reason your 208 might not start is because the spark plugs are been damaged. The spark plugs are responsible to ignite the fuel which starts the engine. However they have a finite life span. They'll eventually break down if they aren't used frequently enough.
Luckily, there's an easy solution for this issue. Check the voltage of the battery with a multimeter. If the voltage is below 11,5 volts then it's time to replace it. It is also important to clean the battery's contacts in the event that it is damaged by corrosion. This can be done by lifting the rubber covers that cover the two battery terminals and using a wire brush to remove any parts that are corroded from the battery. Then, reconnect the cables to the positive and negative poles.
Water Damage
If your 208 isn't starting and the battery is not flat, then you need to make sure whether the spark plugs are functioning. It could be that they're overly dirty, causing them to not to spark. This can be easily corrected by cleaning the spark plugs in an workshop.
Peugeot automobiles use a key with a transponder compatible with the immobiliser. This ensures that only the correct key can turn the engine. If the chip inside the Peugeot key is damaged, it will not transmit the correct signal to the vehicle.
Water damage is a typical cause of this problem. This is a typical issue in areas with colder temperatures where the vehicle is exposed to rain or snow. In this case, contact a reliable locksmith who will have the necessary tools and equipment to change the key's programming. They will also have the most up-to-date technology and the machinery needed to make the peugeot 5008 replacement key 208 smart key. The process shouldn't take more than 15 minutes.
(Image: https://www.thekeylab.co.uk/wp-content/uploads/2022/07/cropped-KeyLab-1.png)Contacts of the battery may be damaged.
Peugeot 107 Replacement key cost replaced the transponder chips using a new type that uses electronic components mounted on a circuitboard. This new system works well when it's new, however, over time, the circuit boards begin to deteriorate and stop working properly.
This could stop the immobiliser's function from being activated, meaning the vehicle won't start. Contact an peugeot 208 replacement key specialist or a locksmith, if this is the situation.
Another issue that is common is when the battery for the key fob is dying, this causes the key blade to stop getting into the lock. A locksmith from your vehicle can replace the battery and cut a new blade for you, this is typically a quick fix.
Faulty Receiver Module
It could be that the receiver module has a problem when your peugeot 107 key fob not working key fob fails to function after being dropped on the floor, or exposed to a sudden rainstorm or accidentally washed. The receiver is responsible for sending radio frequency signals to an on-board computer which controls the centralized locking system inside your Peugeot vehicle.
The key fob itself is fitted with rubber seals to prevent water from getting to the chip inside. However prolonged exposure to water can be able to penetrate these seals and cause damage to the chip. The high salt content in the pool or ocean water can cause damage to the key fob, especially if it is submerged.
The module will need to be replaced if the Peugeot spare key does not work anymore. This is only done by an Peugeot specialist or an expert auto locksmith. Peugeot keys are, unlike other vehicles, are protected by an immobilizer system. This requires the correct code to begin the car. This is the reason that you should only trust a Peugeot locksmith to create and program the replacement.
(Image: https://www.thekeylab.co.uk/wp-content/uploads/2022/06/KeyLab-1-e1658690716312-300x146.png)Computer on-board is not working properly
The on-board computer in your Peugeot is responsible for many of the systems inside your vehicle, from airbags to power windows. The on-board computer displays a code when something goes wrong. The code is stored within the system and stays there until the problem has been resolved. This could mean that the on-board computers to be replaced.
The most frequent cause for the warning light for the airbag to come on is corroded or loose connections within the sensor. This can be caused by wear and tear, aging, or exposure to moisture and salt. It is crucial to get this issue resolved as soon as you can, as an airbag that is malfunctioning can be dangerous in the event of an accident.
If your Peugeot is showing a card that is not being detected error, the battery inside the key fob could be weak or dead. This will stop the key fob from sending a signal to disarm the immobilizer in your vehicle. You can test this by pressing the unlock button on the key fob, then trying to start your vehicle. If this does not work it is because the battery of the key needs to be replaced.